
; VERSION 1.24
;
; STOCK\PHYSICS.TXT
;
; CONFIDENTIAL
; Copyright  1999,2000, Monster Games, Inc.
; All rights reserved.
;
;==========================================================VC##

; physics.txt
; for pontiac.car




Note from Punko. Heat uses the , as a delimiter to separate values High , Low
Example; fspoiler_lift -.31, -.36
Front wing adjusted to minimum is -.31
Front wing set to max is -.36
The comma is a delimiter to separate High and low values.





table Chassis
lite_grip 1.25------------For the AI (corner grip)
lite_power 1.10------------ For the AI (corner speed)

mass 3500------------Weight of Car (weight of car plus 300 lbs / 136 kg of fuel and driver)



mx------------------------ 64000 ------------Mass in X direction (x-axis inertia -- pitch)
my------------------------ 64000 ------------Mass in Y direction (y-axis inertia -- yaw)
mz------------------------ 10000 ------------Mass in Z direction (z-axis inertia -- roll)


width------------------------ 75.0 ------------Total Width of Car body (excluding mirrors)
height------------------------ 51.0 ------------Total Height of car including ground clearance (excluding antennas)
ftrack------------------------ 60.5 ------------ Front track from center of hubs
rtrack------------------------ 60.5 ------------Rear Track from Center of hubs
wheelbase------------ 110.0------------ Wheelbase of Car
cm_height------------ 10.0------------Center of Mass height (also known as center of gravity height)
wheel_lock------------ 0, 35.0------------Range front wheels turn when steering

fuel_capacity------------22.0------------Gal. US / 83 ltr.

frontal_area------------ 19.0 ------------Total frontal area of body in square feet
drag------------------------ 0.30------------Drag on body
cp_height ------------ 18.0------------Center of pressure height
cp_long------------ 51.0------------ Center of pressure length
lat_drag------------ .90 ------------ Lateral drag (side to side)
vert_drag ------------ 2.0------------Vert Drag (up and down)

front_lift------------- -0.025 ------------Front lift on body (numbers with - such as -0.035 are down force)
rear_lift------------ 0.1 ------------ Rear Lift on body

fspoiler_lift------------ -.31, -.36 ------------ Front spoiler or wing lift
fspoiler_drag------------ 0.075, 0.06 ------------ Drag produced by front spoiler or wing

(note: HEAT WC cars add tape to reduce drag and increase front down force at the cost of reducing engine cooling.
GT and formula cars do not have the same condition and adding front spoiler or wing angle will INCREASE front end drag.
The same remark for a GT or formula car would read more like this:

fspoiler_drag------------ 0.06, 0.080


rspoiler_lift------------ -.19, -.40 ------------ Rear wing lift
rspoiler_drrag------------ 0.038, .080------------ Drag produced by rear spoiler or wing

rspoiler_angle------------ 40.0, 70.0------------Angle that shows up in Garage

model_offset------------ 0.0, 1.0, 0.0 ------------Position of body (does not effect physics)

head_pos ------------ -14.2, 38.378, -8.154 ------------driver point of view ( L/R, Up/Down, Front, rear)
head_pitch------------0.0------------Angle of view (Up/Down)

shifter_throw------------10.0, 15.0, 0.0

tachometer------------ 65, 64
tachometer1------------ 0000 21,93
tachometer2------------ 3000 26,28
tachometer3------------ 5000 65,10
tachometer4------------ 8000 114,46
tachometer5------------ 10000 109,89

oil_pressure_gauge ------------52,132
oil_pressure_gauge1------------ 0 30,149
oil_pressure_gauge2------------ 20 26,132
oil_pressure_gauge3------------ 60 62,108
oil_pressure_gauge4------------ 100 73,149

oil_temp_gauge------------ 137,133
oil_temp_gauge1------------ 0 117,149
oil_temp_gauge2-------------140 115,146------------ All these are for movement of needles on gauges
oil_temp_gauge3------------ 180 111,129
oil_temp_gauge4------------ 200 117,117
oil_temp_gauge5------------ 240 147,108
oil_temp_gauge6------------ 260 158,150

water_temp_gauge------------ 80, 133
water_temp_gauge1------------ 0 59,150
water_temp_gauge2------------ 140 57,147
water_temp_gauge3------------ 180 52,129
water_temp_gauge4------------ 200 57,117
water_temp_gauge5------------ 240 89,108
water_temp_gauge6------------ 260 106,123
water_temp_gauge7------------ 280 101,149

fuel_gauge------------ 123,199
fuel_gauge1------------ 0 103,215
fuel_gauge2------------ 3 95,199
fuel_gauge3------------ 6 107,177
fuel_gauge4------------ 12 149,190
fuel_gauge5------------ 20 144,214

volt_gauge------------ 166,146
volt_gauge1------------ 0 144,131
volt_gauge2------------ 10 153,123
volt_gauge3------------ 16 181,122
volt_gauge4------------ 18 183,126

end

table BodySpeedway------------ Speedway section for Super Speedways
frontal_area------------19.0
drag------------0.26 ------------Of Body
cp_height ------------18.0
cp_long------------51.0------------ Note; Cars will go too fast on Speedways
lat_drag------------.90 ------------ So restricting these figures will
vert_drag ------------2.0------------slow them down to normal speeds

front_lift------------0.0------------Of Body
rear_lift------------ 0.1------------Of Body

fspoiler_lift------------ -.17, -.19 ------------Affected by Grill tape settings (as below) or wing/ spoiler setting
fspoiler_drag------------ .030, 0.025 ------------(range of change in drag value ) 0 tape = left value, 100% = right value)
rspoiler_lift------------ -.19, -.40
rspoiler_drag------------ .038, .080

end

table EngineNormal------------ Normal engine (for almost all tracks)
power_max------------720 ------------Total Power
power_rpm------------8000------------RPM at which max power is produced
torque_max------------600------------ Total Torque
torque_rpm------------4800------------ RPM at which total torque is produced
redline------------8600 ------------Redline (shift light)
idle_speed------------ 800------------ Can make car stall if set low
inertia------------15 ------------Total inertia of engine
drag------------.045------------Total internal drag produced by engine (this affects engine spin up time, engine heat range and engine braking forces)
fuel_consumption------------.04 ------------How fast to consume fuel
mass------------360------------Mass of engine
(contrary to previous belief this value is for mass of the engine and has an effect on overall weight location within the car)

displacement------------8.0 ------------ Displacement (Not used)
sound------------eng1 ------------Sound can be eng1 - eng9
(note: 9 possible different engine sounds may be used. for example: WGTC Ferrari 550 uses eng3 sounds)

cold_idle_speed------------1500
engine_temp------------180
oil_pressure------------15, 10, 60
end

table EngineRestrictor------------ Used for restrictor plate racing (on super speedways)
; power_max------------ 520
power_max------------ 364
power_rpm------------6800
; torque_max------------ 600
torque_max------------ 420
torque_rpm------------4500
redline------------8600
idle_speed------------ 800 NOTE; To make car non restrictor plate
inertia------------15 All these should match Engine Normal settings
drag------------.045
fuel_consumption .04
mass------------360
displacement------------8.0
sound------------eng1

cold_idle_speed------------1500
engine_temp------------180
oil_pressure------------15, 10, 60
end

table Transmission
num_gears------------4------------How many gears
inertia------------5------------ How free the tranny is
drag------------.0001

torque_balance------------1.0------------(1.0=rear drive, 0.0=Front drive , Note 0.5=All wheel drive with 50 % of power going to front and rear wheels)
fstiff------------0.0------------differential coupling force (front)
rstiff------------10.0------------differential coupling force (Rear)
cstiff------------0.0------------differential coupling force for the CENTER differential used in some AWD designs
ratio------------3.73------------Final gear ratio (over ridden in garage but sets the range of final gearing)

clutch_torque------------1600
clutch_rpm------------400
end

table Front
camber------------ -10, 10 Sets range of static camber allowed in the garage and the range of camber change during suspension movement.
toe------------ -4, 4 sets the range of static toe-in and toe-in change during suspension movement
ride------------5, 9 sets vertical range of motion and the ground clearance of the axle
caster------------6.0
anti_pitch ------------.10
rc_height------------ 0 Roll center height
bump_camber-------------.20
bump_toe-------------.40
compliance_steer------------.09
compliance_camber------------ 60
torque_steer------------1.0------------Degree of flex per 1000lbs of force
solid_axle------------ no
damage_impulse------------.5------------How easily damage (wheels)
removal_impulse------------.6------------How easily removed (wheels)

rate------------200,600------------Spring rate (divided by 2 for the front axle only.)
Example: 200,600 produces spring rates in the Garage of 400 , 1200 lbs per inch
sway------------0,800 ------------Sway bar range
bump------------60,840------------Shocks
rebound------------60,840------------Shocks
rubber_rate------------400------------ NASCAR rubber rates (also acts as a bump stop rate)
rubber_height------------1.0------------ Same

resistance------------.110 ------------ Rolling resistance
friction------------10 ------------Rolling friction

diameter------------17------------Wheel diameter inches
tire_diameter------------28 ------------ How tall inches
aspect------------35------------Aspect of TIRE sidewall
width------------305 ------------tire tread width in mm

mass------------ 20 ------------Mass of wheel/tire
moment------------350------------ How much the wheel/tire want to keep moving
model------------rtire------------ Tire model used

ref_width 305 ------------ overall width of tire at widest point-usually at the sidewall "bulge"

magic_b------------.714------------ These Magic numbers are used for all wheel drive
magic_c------------1.40------------ No need to mess with these (no one understands them)
magic_d------------1.0
magic_e -------------.20

frict_load1------------800
frict_k1------------1.46------------ Linear function of load on tires max frict coeff used by frict load at lowest load
frict_load2------------2000
frict_k2------------1.25------------Linear function of load on tires max frict coeff used by frict load at highest load

stiff_load1------------ 800
stiff_c1------------ 410 ------------ Cornering stiffness of tire sidewall at lowest load
stiff_load2------------2000
stiff_c2------------633 ------------ Cornering stiffness of tire sidewall at highest load

camber_stiff------------.05
camber_grip------------.09------------ friction at peak, below
camber_peak------------ 5 ------------camber angle of maximal lateral grip
long_stiff ------------1.1------------ longitudinal cornering stiffness as multiple of lateral
long_frict ------------1.4 ------------ " " friction"

brake_force------------0,3000
end

table Rear------------ All the same meanings as above applied to rear axle.
camber------------ -1.5, 1.5
toe------------ -.5, .5
ride------------5, 9
caster------------0.0
anti_pitch ------------.30
rc_height ------------ 4
bump_camber------------ -1.0
bump_toe------------.05
compliance_steer------------.09
compliance_camber------------.01
torque_steer------------0.2
solid_axle ------------yes (sports/GT and Formula cars use "no" to indicate Independant rear suspension)
damage_impulse------------.5
removal_impulse------------.6

rate------------200,600
sway------------0,50
bump------------60,840
rebound------------60,840
rubber_rate------------400
rubber_height------------1.0

resistance------------.110
friction------------10

diameter ------------17
tire_diameter------------28
aspect------------35
width------------305

mass------------24
moment------------ 350
model------------ rtire

ref_width------------305

magic_b------------.714
magic_c------------1.40
magic_d------------1.0
magic_e-------------.20

frict_load1------------800
frict_k1------------1.46
frict_load2------------2000
frict_k2------------1.25

stiff_load1------------ 800

stiff_c1------------418.2
stiff_load2------------2000

stiff_c2------------645.7

camber_stiff------------.05
camber_grip------------.09
camber_peak------------ 5
long_stiff ------------1.1
long_frict ------------1.4

brake_force------------0,3000
end
